Filter
Top Products
—6—
THERMOSTATS AND ACCESSORIES
* Do not use in zoning heat pump applications.
† This plate is designed to cover surrounding wall area located behind thermostat.
‡ Thermostat conversion kit is a 24-vac accessory that can turn a 4-wire thermostat application into a 5-wire application. This kit can also be used
to replace a broken thermostat wire, or add an extra wire when needed.
** Outdoor air temperature sensor is an accessory for all Bryant electronic thermostats, except the non-programmable air conditioner version and
builder’s thermostats. It allows the temperature at a remote location (outdoors) to be displayed on the thermostat.
The outdoor air temperature sensor
must be
used with the dual fuel thermostat.
The outdoor air temperature sensor is included with the Thermidistat Control and dual fuel thermostat.
ACCESSORY USAGE GUIDELINE
* For tubing line sets between 50 and 175 ft and/or 20 ft elevation difference between indoor and outdoor units, refer to the Application Guideline
and Service Manual for Residential Split-System Air Conditioners and Heat Pumps using Puron Refrigerant.
† Required for all applications.
Thermostat—Auto Changeover, Non-Programmable, °F/°C, 2-Stage Heat, 1-Stage Cool TSTATBBNHP01-B
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, 2-Stage Heat, 1-Stage Cool TSTATBBPHP01-B
Thermostat—Auto Changeover, 7-Day Programmable, °F/°C, Dual Fuel, Includes Outdoor
Sensor (TSTATXXSEN01) TSTATBBPDF01-B*
Thermidistat™ Control—Non-Programmable/Programmable Thermostat with Humidity
Control (For use in Dual Fuel, AC, HP, and 2S applications. Includes Outdoor Air
Temperature Sensor.) TSTATBBPRH01-B*
Builder’s Thermostat—Manual Changeover, Non-Programmable, °F/°C, 2-Stage Heat,
1-Stage Cool, Heat Pump TSTATBBBHP01*
Outdoor Air Temperature Sensor TSTATXXSEN01
Backplate for Non-Programmable Thermostat TSTATXXNBP01†
Backplate for Programmable Thermostat and Thermidistat™ Control TSTATXXPBP01†
Backplate for Builder’s Thermostat TSTATXXBBP01†
Thermostat Conversion Kit (4 to 5 Wire)—10 Pack TSTATXXCNV10‡
ACCESSORY
REQUIRED FOR LOW-AMBIENT
APPLICATIONS
(Below 55°F)
REQUIRED FOR LONG-LINE
APPLICATIONS*
(Over 50 Ft)
Crankcase Heater Yes Yes
Evaporator Freeze Thermostat Yes No
Compressor Start Assist—Capacitor and Relay Yes Yes
Puron Low-Ambient Pressure Switch Yes No
Wind Baffle
See Low-Ambient
Pressure Switch Instructions
No
Support Feet Recommended No
Puron Hard Shutoff TXV Yes† Yes†
Puron Liquid-Line Solenoid Valve for Heating No
See Long-Line
Application Guideline