Filter
Top Products
Troubleshooting 183
5
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
18
You changed the stitch pattern settings, and then tried to save them by
pressing the manual memory key.
19
You tried to select an embroidery pattern or change the layout when
the needle was down.
The machine is turned on while the needle is lowered and the
embroidery unit is attached.
20
You tried to initialize the embroidery unit with the embroidery foot
lowered.
21
When 13 or more patterns are in “Removable Disk”, a pattern was
being retrieved.
22
The start/stop button was pressed after selecting a pattern which is
saved in the machine's memory or entered from the USB port without
pressing (Retrieve key).
23
The reverse/reinforcement stitch button, needle position button or
thread cutter button was pressed while the bobbin winder shaft is
moved to the right.
24 A pattern is being saved.
25
The start/stop button or reverse/reinforcement stitch button was pressed
when no pattern is selected.
26
Bobbin thread has run out.
Little bobbin thread remains.
No
Error Message Probable Cause