Filter
Top Products
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Replacing the Presser Foot 41
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
CAUTION
Note
z When sewing with the walking foot, sew at a
speed between slow and medium.
■ Removing the walking foot
a
Press (Needle position button) once or
twice to raise the needle.
a Needle position button
X The needle is raised.
b
Turn off the sewing machine.
c
Raise the presser foot lever.
a Presser foot lever
X The presser foot is raised.
d
With a screwdriver, loosen the presser foot
holder screw, and then remove the walking
foot.
e
Attach the presser foot holder.
• For details, refer to "Removing the presser
foot holder" (page 39).
Memo
z Only the straight stitch (with reinforcement
stitching) and the zigzag stitch can be used
with the walking foot. For details on the
stitches, refer to "Stitch Settings" (page 132).
● Be sure to securely tighten the screw with
the screwdriver, otherwise the needle
may touch the presser foot, causing it to
bend or break.
● Before starting to sew, slowly turn the
balance wheel toward you and check that
the needle does not touch the presser
foot. If the needle hits the presser foot,
the needle may bend or break.
1
1