Filter
Top Products
Troubleshooting 147
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Nothing appears in the LCD
If nothing appears in the LCD when the sewing
machine is turned on, the brightness of the LCD is
either too light or too dark. If this is the case, perform
the following operation.
a
Turn off the sewing machine.
b
While pressing (Back key) in the operation
panel, turn on the sewing machine.
c
Press (–) or (+).
Adjust the brightness of the LCD so that the
screens can be seen.
d
Turn off the sewing machine, then turn it on
again.
Easily adjusting the thread
tension
The sewing machine can be set up so that the tension
of the upper thread can easily be adjusted.
a
Turn off the sewing machine.
b
While holding (Settings key) in the
operation panel pressed, turn on the sewing
machine.
c
When the sewing machine beeps, release
(Settings key).
X The tension of the upper thread can now be
adjusted using the stitch keys.
■ To decrease the tension of the upper thread
Press in the operation panel.
■ To increase the tension of the upper thread
Press in the operation panel.
a Loose
b Tight
Memo
z This setting does not change if the sewing
machine is turned off.
z If the sewing machine is set up in this way,
these keys cannot be used to select stitches.
To use these keys for selecting stitches,
perform the same operation described above
to return the sewing machine to its original
setup.
12