Filter
Top Products
1
2
FOR USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLY.
If your sewing machine is fitted with a 3 pin non-rewireable BS plug then please read the following.
Connecting Plugs and Main Power / Sewing Light Switch
IMPORTANT
If the available socket outlet is not suitable for the plug
supplied with this equipment, it should be cut off and an
appropriate three pin plug fitted. With alternative plugs an
approved fuse must be fitted in the plug.
NOTE: The plug severed from the main leads must be
destroyed as a plug with bared flexible cords is hazardous
if engaged in a live socket outlet. In the event of replacing
the plug fuse, use a fuse approved by ASTA to BS 1362,
i.e. carrying the
ASA
mark, rating as marked on plug.
Always replace the fuse cover. Never use plugs with the
fuse cover removed.
WARNING: DO NOT CONNECT EITHER WIRE TO THE
EARTH TERMINAL WHICH IS MARKED WITH THE LET-
TER ‘E’, BY THE EARTH SYMBOL
OR COLORED
GREEN OR YELLOW.
The wires in these main leads are colored in accordance
with the following code:
Blue Neutral
Brown Live
As the colours of the wiring in the main lead of this appli-
ance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to
the terminal which is marked with the letter ‘N’ or col-
oured black or blue.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter ‘L’ or coloured
red or brown.
1. Connect the three-prong plug into the machine.
2. Connect the electrical supply plug into a wall outlet.
- When leaving the sewing machine unattended, the
main switch of the machine must be switched off or
the plug must be removed from the socket outlet.
Turn on or off the switch for the main power and sew-
light.
1 Turn on
2 Turn off
- When servicing the sewing machine, or when remov-
ing covers or changing lamps, the machine or the
electrical set must be disconnected from the supply
by removing the plug from the socket outlet.