Filter
Top Products
8. ELECTRIC MECHANISM
KE-430B, 430C series
158
Switch No.
Possible setting
range
Units Initial value Explanation
memo-39 0 - 11 0
Changes the reference point for enlargement and reduction
using the operation panel.
0, 1: Center of work clamp,
2: Upper-left corner of work clamp,
3: Lower-left corner of work clamp,
4: Upper-right corner of work clamp,
5: Lower-right corner of work clamp, 6: Sewing start point,
7: Sewing end point, 8: Upper-left corner of sewing pattern,
9: Lower-left corner of sewing pattern,
10: Upper-right corner of sewing pattern,
11: Lower-right corner of sewing pattern
memo-3A 1 - 3 2
Changes the speed limit for the given sewing pitch when the
maximum speed remains constant.
1: Speed limit is increased for the given sewing pitch and the
sewing speed for that pitch is increased.
2: Standard
3: Speed limit is decreased for the given sewing pitch and
the sewing speed for that pitch is decreased.
Note:
If sewing slippage occurs in places where a large sewing
pitch is used, reduce the setting to 3.
Furthermore, sewing slippage may occur in some cases if
setting 1 is used.
memo-3b 0 - 13 0
Changes the work clamp operating mode. (When set to “0”,
the mode is selected according to the settings for DIP
switches A-1 and A-2.) Refer to “8-8. Setting the work clamp
mode” for details on the setting values.
memo-3c 0 - 4 0
Changes the path taken when moving from the machine
home position to the start position.
0: Across inside of work clamp, 1: Top-left, 2: Bottom-left,
3: Bottom-right, 4: Top-right
memo-3d
memo-3E
memo-3F