Filter
Top Products
11. CHANGING SPECIAL FUNCTION AND USING THE MEMORY SWITCHES
BAS-311F-0, 311F-L, 326F-0
61
Memory switches (20 - 2F)
Switch No. When ON
memo-20
During feed test operation, jump feeding 100 stitches at a time is possible using the STEP BACK
switch.
memo-21
After the home position is detected and the machine moves to the sewing start position, the work
clamp rises automatically.
memo-22 When extended option output No. 1 is ON, the sewing machine starts automatically.
memo-23 Set to ON when the bobbin changer is being used. (This part is available by special order.)
memo-24
Feed operation is enabled even if no cassette has been set when the eject device is being used
(memo-03 is ON).
memo-25
The enlargement and reduction ratio settings at the operation panel are fixed at the values when
memo-25 was set to ON.
memo-26 Thread trimming is not carried out.
memo-27 The sewing speed setting at the operation panel is fixed at the value when memo-27 was set to ON.
memo-28 Set to ON when using the thread take-up device.
memo-29 Work clamp lifting and lower thread winding before home position detection are disabled.
memo-2A For program numbers 1 to 15, the program number is output to the extension optional outputs 4 to 7.
memo-2b -
memo-2c -
memo-2d -
memo-2E -
memo-2F
When the input voltage is being checked, the display shows the temperature of the heat sink on the
main circuit board instead of the voltage.
Extended option output
Use the programmer (option).
Required controls for pressing motion and automatic stacking of sewing can be implemented according to various
functions of the machine.
For detail of the extended option output, please consult with your local Brother Sales Office.