Filter
Top Products
10.DIPSWITCH
BAS-311F-0, 311F-L, 326F-0
55
DIP switch A
SW No. When ON
A-5
After sewing is completed, work clamp does not automatically rise (only in split mode)
A-6
Clamping force output is produced (Inner clamping device available as an option)
A-7
Single-pedal operation using the starting switch; when the starting switch is pressed, the work clamp
drops, and when it is released, sewing starts.
A-8
Thread breakage detector device is activated (available as an option)
DIP switch B
SW No. When ON
B-1
Single split mode activated
B-2
BAS-311F-L: The sewing area in the X direction is extended to 230 mm from 220 mm.*
B-3
Needle cooler output is produced.
B-4
Thread is not trimmed after an emergency stop.
B-5
When a rotating-type thread breakage detector device is used, detection precision is increased from 8 to 14.
When a fiber-type thread breakage detector device is used, detection precision is increased from 5 to 10.
B-6 Fiber-type thread breakage detector device is ON, and DIP switch A - 8 is ON (available as an option)
B-7
When using a 3-stage pedal
If DIP switch A -2 is ON at the same time, the presser foot will drop at the same time that both work clamps
drop.
B-8
Feeding speed is switched to high speed.
* <BAS-311F-L only>
If using the work clamp and sewing data for the older BAS-311EL model, set DIP switch B -2 ON.
The BAS-311 L-type has a defferent length for the sewing area in the X derection (X=220 mm).
Old BAS-311EL X -100 mm +120 mm
New BAS-311F-L X -110 mm +110 mm
Note
The break of the sewing pattern is apt to occur in the extended sewing area.