Filter
Top Products
3. INSTALLATION
BAS-311F-0, 311F-L, 326F-0
17
3-18. Installing the feed base cover supports
(BAS-311F-L, 326F-0)
Loosen the four screws (1) on the side of the bed by about 2-3 turns, and then install the feed base cover supports (2) to
the side of the bed so that the top surfaces of the feed base cover supports (2) (one each at left and right) are at the same
height as the top surfaces of the X and Y feed base covers (3) (at left and right).
3-19. Installing the X feed base cover
(BAS-311F-L, 326F-0)
BAS-311F-L
Loosen the four screws (1) by about 2-3 turns, slide the X feed base cover (2) (one each at left and right) in the direction
of the arrow in the illustration, and then tighten the screws (1).
BAS-326F-0
1. Loosen the four screws (2) which are holding the bellows (1) by about 2-3 turns, and then slide the X feed base cover
assemblies (3) (one each at left and right) in the direction of the arrow in the illustration into the gaps (section A)
between the needle plate support plate and the X and Y feed base cover (at left and right).
2. Lift the bellows (1) up slightly, clamp the tops and bottoms of the X feed base cover assemblies (3) (one each at left
and right) between the bellows (1) and the X feed base (4) and the then tighten the screws (2).
1168S
(1)
(2)
Coinside
BAS-311F-L
Coinside
BAS-326F-0
BAS-311F-L
(1)
1 187S
BAS-326F-0
(2)
(3)
(2)
(1)
(2)
(3)
(4)
1 167S1166S
A
1 168S
(1)
(2)
Coinside
BAS-311F-L
(1)
(2)
Coinside
BAS-326F-0
(2)
(3)
Coinside
1 169S 1 186S