Filter
Top Products
TROUBLESHOOTING
Maintenance and Troubleshooting
Appendix A-21
A
2
d
Raise the presser foot using the presser foot
lever.
* If the presser foot is not raised, the sewing machine
cannot be threaded correctly.
e
Raise the needle by turning the handwheel
toward you (counterclockwise) so that the
mark on the wheel points up, or press
“Needle Position” button once or twice to
raise the needle.
or
a Mark
f
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a Thread guide plate
g
While holding the thread in your right
hand, pass the thread through the thread
guide in the direction indicated.
h
Guide the thread down, up, then down
through the groove, as shown in the
illustration.
i
Pass the thread through the needle bar
thread guide (marked “6”) by holding the
thread with both hands and guiding it as
shown in the illustration.
a Needle bar thread guide
j
Thread the needle according to steps j
and
o in “Upper Threading” on page B-42.
Memo
• Look in the upper groove area to check if
the thread catches on the take-up lever
visible inside the upper groove area.
a Look in the upper groove area