Filter
Top Products
MONOGRAMMING, USING EMBROIDERY HOOP
SET YOUR SEWING MACHINE AS PER FOLLOWING TABLE.
1. Remove presser foot.
2. Draw lettering on the right side of the
material.
3. Stretch work between embroidery hoops
as firmly as possible.
4. Place the work under the needle and
lower presser bar.
5. Pull lower thread up through the material
at starting position by turning balance
wheel and holding both threads.
6. Hold the hoop with thumb and forefinger
of both hands while pressing the material
with middle and third fingers and
supporting the outside of hoop with
smaller finger.
7. Start sewing, moving hoop lightly along
the lettering with even rate of speed
while controlling zigzag width lever
with your right hand.
-26-