Filter
Top Products
HOW TO FINISH YOUR SEWING PROJECT
(REVERSE STITCHING)
Reverse stitching is used to reinforce stitches near
the edge of material or wherever reinforcement is
needed.
1. That is done by stitching to the material edge…
then stopping.
2. Push Reverse Sewing Button and stitch
backwards for ½ inch (10mm) from material
edge.
HOW TO REMOVE FINAL SEWING FROM
MACHINE
1. Stop the machine.
2. Raise needle to its highest position and make
sure that the thread take-up lever is in the
highest position also.
3. Lift presser foot and pull out the material gently
to the left side diagonally.
4. Cut both threads on the thread cutter.
5. Leave 4 inches (10cm) of thread between the
presser foot loose while the thread take-up lever
is at highest position. You are ready to sew.
HOW TO GUIDE AND SUPPORT MATERIAL
Generally it is enough to guide the material in front
of the presser foot as shown in the upper
illustration.
However, in case of special materials such as tricot,
crepes, knits, etc., we recommend you to support
the material both in front and back of the presser
foot with gentle tension as shown in the lower
illustration.
-18-