Brother 436C Sewing Machine User Manual


 
8. ELECTRIC MECHANISM
--. DIP switches inside the control box
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the
wall outlet before opening the face plate of the control box. Touching areas where high voltages are
present can result in severe injury.
No
te:
When opening the cover, hold it securely
so that it does not fall down.
A
ll DIP switches are set to OFF at the time o
f
shipment.
3616Q
Switch Motion when set to ON
DIP-1 First two stitches are sewn at a low speed of 260 rpm.
DIP-2 Last two stitches are sewn at a low speed of 260 rpm.
DIP-3 -
DIP-4 Last two stitches are sewn at a low speed of 700 rpm.
DIP-5 First two stitches are sewn at a low speed of 400 rpm.
DIP-6 Low speed sewing is not performed at the start of sewing.
DIP-7
The motor operates in reverse when the upper shaft stops, to return the needle
bar to close to its highest position.
*NOTE
Maximum area for the sewing data is increased.
DIP-8
<KE-436B, 436C>
During an emergency stop, the thread is trimmed and the needle bar stops in the
raised position.
*Note:
When the motor operates in reverse to raise the needle, the thread take-up will stop at a position which is
lower than its normal stopping position. As a result, the thread take-up will rise slightly at the sewing start,
and this may result in the thread pulling out under certain conditions.
KE-430B, 430C series
149