Filter
Top Products
Decorative Stitching 117
—
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
—
3
d
Start sewing.
CAUTION
Partially removing threads is called “drawnwork”.
This gives a beautiful result with fabrics that have a
loose weave.
Two ways to create drawnwork are described below.
■ Drawnwork (Example 1)
a
Pull out several threads from the fabric.
b
Attach monogramming foot “N”.
• For details, refer to “Replacing the presser
foot” (page 41).
c
Select stitch
39
.
• For details, refer to “Selecting stitching” (page
72).
d
With the right side of the fabric facing up, sew
along the right edge of the frayed section.
e
Press (Settings key) in the operation
panel.
X The settings screen appears.
f
Press or (Stitch length keys) until
is displayed.
X
9The screen for mirror imaging the pattern
appears.
● Select a stitch width of 6.0 mm (15/64
inch) or less, otherwise the needle may
bend or break.
● After adjusting the stitch width, slowly
turn the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the
needle may bend or break.
N