Filter
Top Products
Error Code Definitions
For models with Honeywell Integrated Control
ERROR CODE DEFINITIONS
I
f the water heater has an operating problem, there will be a number in the water heater display with
“Service Needed” shown below the error code number. Note the error code and the definition in the
chart below. This label appears on the control box under the water heater display. The following
sections will provide instructions for servicing each error code.
33
HONEYWELL INTEGRATED CONTROL ERROR CODE
DISPLAY FOR EF MODEL SERIES
LOW FLAME SENSE CURRENT
FLAME SENSED OUT OF NORMAL SEQUENCE (BEFORE OPENING GAS VALVE OR AFTER CLOSING GAS VALVE)
FLAME DETECTED BEFORE IGNITION
FLAME DETECTED AFTER A HEATING CYCLE COMPLETES
PRESSURE SWITCH FAILED TO CLOSE OR OPEN (STUCK OPEN)
LOWER SENSOR READINGS FAULTY
FLAME ROD SHORTED TO GROUND
AC LINE FREQUENCY ERROR - SIGNAL TOO NOISY OR FREQUENCY INCORRECT
LINE VOLTAGE TOO LOW OR HIGH
DC OUTPUT VOLTAGE UNSTABLE
MAXIMUM NUMBER OF RETRIES DETECTED
MAXIMUM NUMBER OF IGNITION RECYCLES DETECTED
ELECTRONICS FAILURE
HIGH WATER TEMPERATURE (OVER 200°F)
4
6
23
24
29
32
57
58
59
61
62
63
64
65
DEFINITION
ERROR
CODE
IF ANY OF THE ABOVE CODES APPEAR ON THE CONTROL DISPLAY, CONTACT YOUR PLUMBER OR QUALIFIED SERVICE AGENT FOR SERVICE OF THE WATER HEATER.
33