Brada Appliances MPN1-10CR Air Conditioner User Manual


 
REMOTECONTROLLERILLUSTRATION
Usetheremotecontrollerwithinadistanceof8
metersfromtheappliance,pointingittowardsthe
receiver.Receptionisconfirmedbyabeep.
Locationof theremotecontroller.
8m
CAUTIONS
Theairconditionerwillnotoperateifcurtains,doorsorothermaterialsblockthesignals
fromtheremotecontrollertotheindoorunit.
Preventanyliquidfromfallingintotheremotecontroller.Donotexposetheremote
controllertodirectsunlightorheat.
Iftheinfraredsignalreceiverontheindoorunitisexposedtodirectsunlight,theair
conditionermaynotfunctionproperly.Usecurtainstopreventthesunlightfromfalling
onthereceiver.
Ifotherelectricalappliancesreacttotheremotecontroller.eithermove
theseappliancesorconsultyourlocaldealer.
Theremotecontrollerispowedbytwodrybatteries(R03/LR03X2)
housedintherearpartandprotectedbyacover.
(1)Removethecoverbypressingandslidingoff.
(2)Removetheoldbatteriesandinsertthenewbatteries,placing
the(+)and(-)endscorrectly.
(3)Reattachthecoverbyslidingitbackintoposition.
Whenthebatteriesareremoved,theremotecontrollererases
allprogramming. Afterinsertingnewbatteries,theremote
controllermustbereprogrammed.
NOTE:
Replacingbatteries
.
Handlingtheremotecontroller
TEMP
AUTO
COOL
DRY
FAN
HIGH
MED
LOW
MODE
FANSPEED
SWING
TIMERON
ECONOMY
ON/OFF
TIMEROFF
RESETLOCK
SETTEMPERATURE(F)
LED
DISPLAY
CAUTIONS
Donotmixoldandnewbatteriesorbatteriesofadifferenttype.
Donotleavethebatteriesintheremotecontrollerifitisnotgoingtobeusedfor2or3months.
Disposeoftheoldbatteriesinthespecialcontainerstobefoundinthesalesoutlets.
17