Brada Appliances MPN1-10CR Air Conditioner User Manual


  Open as PDF
of 24
 
CARE AND MAINTENANCE
CAREANDMAINTENANCE
1)Besuretounplugtheunitbeforecleaningorservicing.
2)Donotusegasoline,thinnerorotherchemicalstoclean
theunit.
3)Donotwashtheunitdirectlyunderataporusingahose.
Itmaycauseelectricaldanger.
4)Ifthepowercordisdamaged,itshouldberepairedby
manufactureroritsagent.
IMPORTANT:
1. Airfilter
-Cleantheairfilteratleastoncetwoweekstoprevent
inferiorfanoperationbecauseofdust.
-
Thisunithastwofilters.Grasptheupperfiltertab(Fig.22),
pullthefilterout.Removethelowerfilterbylooseningthe
screws,takedowntheairinletgrille,thenremovetheair
filterasshowninFig.23&24.
-
Washtheairfilterbyimmersingitgentlyinwarmwater
(about40 C/104 F)withaneutraldetergent.Rinsethefilter
anddryitinashadyplace.
-
Inserttheupperairfilterfromupwardaftercleaning,attach
thelowerairfilterontheairinletgrille,theninstallthegrille
byusingthescrew.
Removal
Cleaning
Mounting
O O
2.Unitenclosure
-Usealint-freeclothsoakedwithneutraldetergenttoclean
theunitenclosure.Finishedbyadrycleancloth.
3.Unitidleforalongtime
,,
-Removetherubberplugatthebackoftheunitandattach
ahosetodrainoutlet
(SeeFig.4&5).
-Removetheplugfromthebottomdrainoutlet,allthewater
inthebottomtraywoulddrainout(SeeFig.6).
-KeeptheappliancerunningonFANmodeforhalfadayin
awarmroomtodrytheapplianceinsideandpreventmold.
-Stoptheapplianceandunplugit,wrapthecordand
bundleitwiththetape(Fig.25).Removethebatteriesfrom
theremotecontroller.
-Cleantheairfilterandreinstallit.
-Unscrewtheexhausthosetotherightorleftandpullout
foruninstallation(Fig.26),keepitsafety.
.Placetheopenendofthehose
directlyoverthedrainareainyourbasementfloor
Fig.22
Airfilter
(slideout)
Fig.23
Fig.25
Removethe
screwand
taketheair
inletgrille
down
Removetheairfilter
outfromthegrille
Fig.24
Band
Powercord
Fig.26
15
 previous next