Filter
Top Products
EN | 90 Installation and Operating Manual | VIP X2
Configuration using a Web browser Bosch Security Systems | 2006-12 | V2.5
Multicast address video 1: / Multicast address video 2:
Enter a valid multicast address for each stream from the relevant encoder (video
input) to be operated in multicast mode (duplication of the data streams in the
network).
With the setting 0.0.0.0 the encoder for the relevant stream operates in multi-uni-
cast mode (copying of data streams in the unit). The VIP X2 supports multi-uni-
cast connections for up to five simultaneously connected receivers.
Note
Duplication of data places a heavy demand on the unit and can lead to im-
pairment of the image quality under certain circumstances.
Port:
Assign a different port to each data stream if there are simultaneous data
streams at the same multicast address.
Enter the port address of the required stream here.
Streaming
Click the checkbox to activate multicast streaming mode for the relevant stream.
An enabled stream is indicated by a check mark.
Multicast packet TTL:
You can enter a value to specify how long the multicast data packets are active
on the network. This value must be greater than one if multicast is to be run via
a router.