Filter
Top Products
VIP X2 | Installation and Operating Manual EN | 83
Bosch Security Systems | 2006-12 | V2.5 Configuration using a Web browser
COM1
You can configure the serial interface parameters (orange terminal block) to
meet your requirements.
Note
If the VIP X2 is working in multicast mode (see page 89), the first remote
location to establish a video connection to the unit is also assigned the
transparent data connection. However after about 15 seconds of inactivity
the data connection is automatically terminated and another remote loca-
tion can exchange transparent data with the unit.
Serial port function:
Select a controllable unit from the list. If you wish to use the serial port to transmit
transparent data, select Transparent. Select Terminal if you wish to operate
the unit from a terminal.
Note
After selecting a unit, the remaining parameters in the window are set au-
tomatically and should not be changed.
Camera ID:
If necessary, enter the ID of the peripheral you wish to control (for example a
dome camera or pan/tilt head). The ID set refers to the peripheral device con-
nected to the first video input. For each video input following the ID is incre-
mented automatically and assigned to the connected peripheral device.