Filter
Top Products
D1255RB/D1256RB/D1257RB | Installation Instructions | 4.0 D1256RB Programming Requirements
.
Bosch Security Systems, Inc. | 8/06 | F01U011791B 9
4.0 D1256RB Programming
Requirements
For D1255RB and D1257RB programming
information, refer to the appropriate
program entry guide and program record
sheet for the control panel.
Important programming recommendations and
requirements are described in this section. For
information about the displays and functions available
from the D1256RB, refer to Keypad (Command Center),
User Interface, and Function List in the GV2MAIN section,
and User (Passcode) Worksheet in the RADXUSR1 Handler
or RADXUSR1/RADXUSR2 Handlers section of the
program record sheet for the control panel.
4.1 Keypad (COMMAND CENTER)
Assignments
• Keypad Text: The D1256RB can be assigned to
any one of the eight addresses in the control panel.
Refer to Sections 4.2 Area Text, 4.3 Custom Functions
on page 10, and 4.4 Function List on page 10 for
programming descriptions for one D1256RB
assigned to Keypad 1, Area 1.
• Supervised: Certain local jurisdictions might
require supervision of fire system annunciators. If
your area has that requirement, set the supervision
to YES for the addresses that use fire alarm
annunciators.
• Scope: The D1256RB acknowledges fire alarms
and troubles, not burglar alarms and troubles. Set
the scope to include fire areas only.
• Area: Program the area number of the fire area(s)
as normal.
4.2 Area Text
Figure 14: Example – Area Text for Fire Applications
Area 1 Area 2
Area # is On
P R E S S A L A R M S I L _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Area # Not Ready
C H E C K F I R E S Y S _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Area # is Off
* F I R E S Y S T E M * _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Area # Acct is On
P R E S S A L A R M S I L _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Area # is On − PRESS ALARM SIL
Fire area should remain in the OFF state at all times. If the authority level is not programmed correctly, and the
fire alarm area arms, PRESS ALARM SIL shows on the display. Pressing the [ALARM SILENCE] key silences
any alarms(s) and disarms the area.
The idle text, * FIRE SYSTEM *, appears on the display when the area is disarmed.
Area # Not Ready − CHECK FIRE SYS
Most fire alarm areas consist of all 24-hour points and the Area # Not Ready display is not used. If a controlled
point type is used for some type of fire supervision device, and the device becomes off-normal, CHECK FIRE
SYS appears on the fire keypad.
Area # is Off − * FIRE SYSTEM *
This is the normal idle text for the fire keypad and annunciator.
Area # Acct is On − PRESS ALARM SIL
Fire area should remain in the OFF state at all times. If the authority level is not programmed correctly, and the
fire alarm area arms, PRESS ALARM SIL shows on the display. Pressing the [ALARM SILENCE] key silences
any alarms(s) and disarms the area.
The idle text, * FIRE SYSTEM *, appears on the display when the area is disarmed.