Filter
Top Products
Bosch Security Systems | 2003-06 | 3922 988 54284
CCS 800 Ultro | Installation and Operating Manual en | 10
5.8 Connecting a telephone coupler
Figure 5.8
Connect the telephone coupler (2) to the telephone
input and output of the CPSU (1). The telephone
coupler is further connected to the telephone wall
socket (4) and a telephone (3) for dialing.
A connection to a telephone network must always be
made via a telephone coupler that provides adequate
isolation between the telephone network (PBX) and the
CCS 800 Ultro system. The telephone coupler shall also
meet all relevant requirements for this type of
communication equipment as imposed by law and/or
responsible telecommunication organisations in the
country of use.
5.9 Connecting an equalizer
Figure 5.9
Put the insertion switch (3) in position "0" and connect
the cabling (2) of the (mono) equalizer (4) to the
insertion input and output of the CPSU (1). Switch (3)
must be in position "1" (loop through) if the insertion
input/output is not used.
5.10 Mains connection
Figure 5.10
Use the supplied mains cord set (5) to connect the
CPSU (1) to the mains supply (2). Press the on/off
switch (3) to power up the system, the power on LED (4)
will lit.
Caution
Never try to make a direct connection between
the telephone network and the CCS 800 Ultro
discussion system.
GainGain
Recorder Line
Telephone
Insertion
In
Out
2
1
3
4
GainGain
Recorder Line Telephone
Insertion
In
Out
2
1
3
4
GainGain
90-260 V~
Trunk in/out Recorder Line Telephone InsertionMicrophone
In
Out
1
2
3
4
CCS
800 ULTRO
0
1
2
3
4
5
6
7
8
9
10
0
1
2
3
4
5
6
7
8
9
10
4
3
2
1
1
2
3
4
5
Digital Acoustic
Feedback Suppression