Filter
Top Products
9
Set up the machine following instructions on
pages 5-8.
Use Fiber Cleansing Formula in the SmartMix tank.
Choose the SmartMix setting to match the cleaning job.
Set the ReadyTools
™
switch on to either Tools/PreTreat or
Floor Cleaning.
Improves cleaning effectiveness for heavily soiled carpet in
high traffic areas such as entryways and hallways:
Set the SmartMix dial to High Traffic.
Set the ReadyTools dial to PreTreat.
Plug into a proper outlet and turn ON the Power switch.
While pressing the trigger, slowly make several passes over the
area to be cleaned.
Caution: Do not overwet.
Turn the machine Power switch OFF and let BISSELL Fiber
Cleansing Formula dissolve the tough soil for 1-2 minutes
before continuing.
Plug into a proper outlet and turn the Power switch ON.
While pressing the trigger make one slow forward and back wet
pass. Let the Fiber Cleansing Formula and DirtLifter PowerBrush
do the work for you. Caution: Do not overwet.
Release the trigger and make one slow forward and back pass
over the same area to remove any residual dirty water.
Repeat cleaning passes until solution being pulled up appears clean.
Continue passes without pressing the trigger until you can’t see
any more water being pulled up.
NOTE: Both the SmartMix and the clean water tanks must
have liquid in them in order for the machine to spray.
If one tank is empty the machine will not apply
either cleaning solution or water only.
After cleaning, you may want to turn the SmartMix to Water
Only to give your carpeting a final rinse. This will insure
thorough removal of embedded dirt loosened by the Fiber
Cleansing Formula. BISSELL Fiber Cleansing Formula
contains an anti-resoiling agent that helps your carpets repel
dirt and keeps them looking clean longer. If you choose to rinse
your carpets, you may want to apply BISSELL Carpet Protector
after rinsing. Follow the label instructions.
When the cleaning job is complete refer to the Maintenance/
Storage section on page 12.
1.
2.
1.
2.
Machine Preparation
1.
2.
3.
3.
4.
Pre-Treating (Optional)
4.
5.
Normal Cleaning
3.
4.
5.
When filling bottle or
storing unit, set
dial to:
6.
7.
ug310-5926_1697_1205.indd 9ug310-5926_1697_1205.indd 9 12/21/05 3:51:36 PM12/21/05 3:51:36 PM