Filter
Top Products
7
Find the mouth of the bladder and fill to the bottom of the
neck with hot tap water. *Do not boil or microwave water.
NOTE: Fill the Bladder with water only.
Replace the tank lid matching the lid and tank edges.
Handle must be in forward position to reinstall.
Rotate the handle to the carrying position to re-latch
the lid.
Replace tank in machine base, seating firmly in place.
Rotate handle back down to the latched position.
Remove the Tank-in-Tank – follow steps 1 and 2
on page 6.
Carry the Tank-in-Tank, like a bucket, to the sink where
you will dispose of the dirty water.
Remove tank lid.
Pour out dirty water.
After each use, remove and rinse the lint screen located
on the tank lid.
Remove tank assembly from unit.
Remove tank lid.
Remove lint screen and rinse under faucet.
Remove any debris caught in lint screen.
Replace lint screen on tank lid. Lint screen will
click into place.
Replace tank lid.
Replace tank assembly into unit.
Refill with clean tap water as above, steps 5 through 9,
and refill the SmartMix tank with BISSELL Cleansing
Formula, as necessary.
Tank-in-Tank
™
(Continued)
5.
6.
7.
8.
1.
2.
6.
WARNING: To reduce the risk of fire, use only
BISSELL Fiber Cleansing Formula or BISSELL Hard
Floor Solutions
in your POWERSTEAMER. Use of
cleaning formulas which contain lemon or pine oil may
damage this appliance and void warranty. Chemical spot
cleaners or solvent-based soil removers should not be used.
These products may react with the plastic materials used in
your POWERSTEAMER causing cracking or pitting.
9.
Fill Bladder
only with clean
tap water
Emptying Tank-in-Tank
3.
4.
5.
A.
B.
C.
D.
E.
F.
Lint Screen
C.
D.
Pour Out
Dirty Water
When filling bottle or
storing unit, set
dial to:
ug310-5926_1697_1205.indd 7ug310-5926_1697_1205.indd 7 12/21/05 3:51:34 PM12/21/05 3:51:34 PM