Filter
Top Products
Troubleshooting (Continued)
1
1
2 2
3
3
4 4
5
5
6 6
Lift Here
Insert Screwdriver Blade Here
14
6
6
Reduced Spray Or No Spray (Continued).
Possible Causes Remedies
The Pump Belt may be broken. Turn the machine OFF and unplug
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert
the blade end into the lower slot of
the Belt Access door to release the
lower snap. If necessary, insert the
blade end into the upper slot
to release the upper snap.
Examine the belt for breakage. You
should be able to see the Pump Belt
looped around the motor shaft. If it is
broken or missing, please refer to
Replacement Parts on page 15
before calling Consumer Services.
Complete installation instructions will
accompany the replacement belt.
PowerSteamer is not picking up solution.
Possible Causes Remedies
ReadyTools Dial may be at the Set ReadyTools Dial to either FLOOR
wrong setting for cleaning job. CLEANING or TOOLS/PRETREAT.
Nozzle Window may not be properly attached. Make sure the two tabs on the back
of the Floor Nozzle Window are
inserted through the mating slots in
the main housing. Reinstall
if necessary.
Tank-in-Tank Lid is not properly installed. Reinstall lid; refer to page 6.
Tank-in-Tank is not properly seated. Tank-in-Tank must be firmly seated to
function. Remove tank and check gasket
on tank bottom; Reseat tank.
Poor tool position. Readjust angle; apply more
(Handheld attachments only) downward pressure.
Tank-in-Tank has picked up the maximum Empty tank and refill; refer to
dirty water. page 7.
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operations, call 1-800-237-7691.
Please do not return this product to the store
ug310-5926_1697_1205.indd 14ug310-5926_1697_1205.indd 14 12/21/05 3:51:43 PM12/21/05 3:51:43 PM