Filter
Top Products
21
Troubleshooting Continued
DirtLifter PowerBrush does not turn.
Possible Causes Remedies
The Brush Belt or Pump Belt is off or broken Turn the machine OFF and unplug from
the outlet. To check if a Pump Belt has
broken, you will need a flat head screwdriver.
Insert the blade end into the lower slot of the
Belt Access door to release the lower snap. If
necessary, insert the blade end into the upper
slot to release the upper snap. Examine the
belt for breakage. If broken refer to pages 18-19.
Carpet Protector is not spraying.
Possible Causes Remedies
Bottle not connected properly to the tool. Follow instructions on cartridge
assuring proper fit.
Solution clogging the Spray trigger. Soak applicator tool only in hot water.
Spray without the cartridge attached to
purge any residual Solution left in the tool.
Applicator tool spray is blocked. Soak applicator tool only in hot water.
Spray without the cartridge attached to purge
any residual Solution left in the tool.
SmartMix not set on water/rinse Set to proper setting.
carpet protector setting.
ReadyTool dial not set on tool setting. Set to tool setting.
Cleaner not picking up solution.
Possible Cause Remedies
Ready Tools dial may be at the Set ReadyTools dial to either Tools or
wrong setting for the cleaning job. PreTreat or Floor Cleaning.
Nozzle Window may not be properly attached. Press down firmly on the black oval gasket at
the top window to make sure the two tabs on
the back of the Nozzle Window are snapped
into the mating slots in the main housing.
Tank-in-Tank lid is not properly installed. Re-install lid; refer to The Operations section,
page 10
Tank-in-Tank is not properly seated. Tank-In-Tank must be firmly seated to
function; remove and reseat Tank-in-Tank.
Poor tool position. (Hand held attachments only). Adjust angle; apply more downward pressure.
Tank-in-Tank has picked up maximum dirty water. Empty Tank-in-Tank, refer to The Operations section,
page 10
1
1
2
2
3
3
1
1
4
4
5
5
1
1
2
2
3
3
4
4
5
5
6
6