Filter
Top Products
13
(Available on select models only)
Unplug cleaner from the outlet before attaching TurboBrush. Attach
TurboBrush to the Flex Hose by pressing tool onto the Grip/Trigger
until button snaps into hole. Make certain tool is securely in place.
Move the TurboBrush switch to the “BRUSH” position.
This activates the brush when the unit is running.
Place the tool directly on the soiled surface. Apply
downward pressure on the tool and pull towards you
while pulling trigger to spray cleaning solution.
Release the spray trigger and move the switch to the
“SUCTION” position. Vacuum the area until no more
cleaning solution can be removed.
Repeat steps 1-3 until no more dirt can be removed.
Caution: Do not overwet.
Disconnect the TurboBrush from the Flex Hose by pushing
down on the button lock and pulling straight off.
Once removed from the Flex Hose, the TurboBrush can
be cleaned.
A) Move the switch to the “SUCTION” position
B) Rinse under running water.
C) Check spray nozzle for dirt. If necessary, clean with
a soft bristle brush.
D) Replace TurboBrush in its special storage
location on the Tool Caddy in back.
(available on select models only)
1.
2.
3.
4.
Assembly
Use
When You’re Done
1.
2.
TurboBrush
™
BRUSH
SUCTION