Filter
Top Products
11
WARNING:
To reduce the risk of
injury from moving
parts, turn off vacuum
cleaner and discon-
nect Power Plug from
electrical outlet.
Check Rotating Floor Brush and Drive Belt
Unplug cleaner from electrical outlet.
Place handle in Low position and turn vacuum
cleaner over so bottom side is up.
Remove the four screws as shown with a Phillips
head screwdriver. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and
lift up.
Clean strings, hair and other debris from Rotating
Floor Brush, paying particular attention to
brush ends.
Clean strings, hair and other debris from Motor
Pulley and Drive Belt areas.
Check Drive Belt carefully for wear, cuts or
stressed areas.
Check Air Passageway for obstructions. Remove
debris from this area.
You should check your vacuum cleaner’s Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of string, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any
debris that has accumulated under the brush cover.
Replace Drive Belt
1.
2.
3.
5.
4.
6.
7.
8.
Brush
Cover
Unplug cleaner from electrical outlet.
With Rotating Floor Brush removed from vacuum
cleaner ( Steps 1-4 above), stretch old Drive Belt
to clear Motor Pulley and remove. Discard old
Drive Belt.
Place new Drive Belt over Motor Pulley and
stretch other end over Rotating Floor Brush.
3.
2.
1.
Use only BISSELL Style 7 Replacement Belts (#32074) in
your BISSELL PowerGlide.