Filter
Top Products
13Setting up the sewing computer
Bobbin case
To remove the bobbin case
•
raise the needle
•
turn power switch to «0»
•
open the bobbin cover
•
grasp the latch of the bobbin
case
•
remove case
To insert the bobbin case
•
hold the bobbin case latch
•
the finger on the case should
point upwards
•
insert so that it clicks into
place
Bobbin thread cutter
•
insert the bobbin case
•
take the thread over cutter A
•
thread is cut
•
close the bobbin cover
Note:
The bobbin thread does not
have to be brought up as
the loose end is just the right
length to start sewing.
Refer to the safety
instruction!
A
135_145_S_engl 14.3.2003 15:33 Uhr Seite 13
030529.52.04_0303_a135 a145_EN