Filter
Top Products
17
PureAV Power Console
Hookup and Installation
Step 10
Connect your Cable TV/Satellite Coaxial Lines
Your PureAV Power Console comes with two pairs of F-type coaxial-
cable connections, and one pair of aerial-cable connections to protect
your system from dangerous electrical disturbances that can travel
down your cable/satellite/aerial-signal lines. You will need additional
coaxial cables to connect the Power Console to your home cinema
components.
A. Satellite (DSS) TV – Connect the incoming satellite television F-type
coaxial-cable line to the connector labeled “SAT IN”. Connect one
end of a second coaxial cable to the connector labeled “SAT OUT”.
Connect the other end of this cable to your satellite TV tuner.
B. Cable TV – Connect the incoming cable television F-type coaxial-cable
line to the connector labeled “Cable IN”. Connect one end of a second
coaxial cable to the connector labeled “Cable OUT”. Connect the
other end of this cable to your cable TV set-top box.
C.
Antenna – Connect the incoming TV or radio antenna cable line to the
connector labeled “Antenna IN”. Connect one end of a second aerial
cable to the connector labeled “Antenna OUT”. Connect the other end
of this cable to your TV or radio equipment.
Note: We have included labels for the “Coax IN” and “Coax OUT” lines,
if needed, for better organisation.
IMPORTANT WARNING: To sufficiently safeguard all of your
equipment from damage resulting from a power surge, all of your
incoming coaxial-cable lines should be properly earthed. Contact a
licensed electrician to verify that all of your cable lines are properly
earthed to a cold water pipe or earth rod.