Filter
Top Products
PureAV Power Console
Hookup and Installation
Step 4
Remote DC Operation
This function allows you to turn your Power Console on and off via any
component that is equipped with a 3~30V DC output (low-voltage
trigger out).
Note: You cannot turn off the switched sockets on the Power Console
with the “Switched” button on the front of the unit when there is
any external power signal supplied to either the AC or DC remote
inputs.
To install the Remote DC Control Cable:
A. Connect the Remote DC Control Cable (included) into the socket
labeled “DC IN” on the rear panel of the Power Console. (Fig. 4a)
B. Press the “Remote” button on the front of the Power Console to turn
on the remote function. The LCD display should read “REMOTE ON”.
(Fig. 4b)
C. Press the “Switched” button on the front of the Power Console to
turn off the switched sockets.
D. Connect the other end of the Remote DC Control Cable into the
3~30V output (low-voltage trigger out) on your component. When
you turn on the component, the sockets on the Power Console that
are programmed as “Switched” will be turned on immediately and
the “Switched/Delayed” sockets will come on after a delay set by the
“Delay Time Switch”.
11
Fig. 4a Fig. 4b