Filter
Top Products
1. Lamp House with 2.5 kW lamp
1. LAMP HOUSE WITH 2 .5 KW LAMP
Purpose of the Lamp House with 2.5 kW lamp
The Lamp House with 2.5 kW lamp is exclusively designed for the Barco HDX series and can thus not be used on any other equip-
ment.
Overview
• Introduction
• Safety
1.1 Introduction
Order info & content of the kit
When ordering the Lamp House with 2.5 kW lamp for HDX s eries, refer to article number R986 4130.
The table below gives an overview of the content of the kit.
Article numb er Description
Quan tity
Image
R5905109 This installation manual 1 image 1-1
R856950 Lamp House with 2.5 kW lamp 1 image 1-2
Image 1-1 Image 1-2
1.2 Safety
Safety instructions
Read and heed the following warnings and cautions.
WARNING: The procedures below may only be performed by Barco trained and qualified technicians.
WARNING: The projector must be cooled dow n before removing an y of the projector covers: wait fo r the cool
down cycle to finish after switching the projector to standby (the sound of the fans comes to a very low level)
and wait for 15 more minutes before starting any of t he procedures below.
WARNING: Unplug the mains power supply cord in order to completely cut off the power supply to the pro-
jector. Failure to do so can cause serious injury o r death.
R5905109 LAMP HOUSE WITH 2.5 KW LAMP 27/05/2014 3