Filter
Top Products
Installation 7
Travis Industries 4050525 100-01144
Before You Begin
READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE THIS HEATER.
FAILURE TO FOLLOW THE INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE,
BODILY INJURY, OR EVEN DEATH.
Check with local building officials for any permits required for installation of this pellet heater and notify
your insurance company before proceeding with installation.
Packing List
• Thermostat & Wire • Scraper Rod Tool • Fuses (2) • Fireplace Installation Sticker • Brush
• Leveling Bolts (2) • Control Board Screws • Hopper Screws • Double-Back Tape (for panels)
Installation Options:
• Masonry Fireplace • Factory Built (Metal) Fireplace • Outside Air Compatible
Planning The Installation
• Have an authorized Travis Industries dealer install this heater. If you install the heater yourself, have
your dealer review your installation plans.
• Place the heater outside and load 10 pounds of pellets inside the hopper. Plug the heater in and
let it run on HIGH until the pellets run out. This will cure the paint and burn off any oil on the steel,
eliminating any smell inside the home.
• Inspect the chimney and clean as necessary before installing the heater. NOTE: The convection
blower is open to the fireplace cavity and may circulate odors from the fireplace. You may wish to
paint the interior of the fireplace with latex paint to prevent odors from entering the home.
Minimum Fireplace Size
Min. 36"
(6" from door
opening)
Min. 36"
(includes circuit board)
Mantel
(combustible or non-combustible)
Non-Combustible
Facing
Min. 32-3/4"
(6-1/4" from
hopper lid)
Min. 18"
Non-Combustible Hearth
Min. 14"
Min.42"
(7" from hopper
lid)
See "Mantel
Requirements" for
details
25-3/4” - 20” See
“Hopper Extension
Set-up”