Filter
Top Products
6 Specifications
Travis Industries 4050525 100-01144
Heating Specifications:
Approximate Maximum Heating Capacity (in square feet)* ........................................800 to 2,250
Burn Rate (Pounds per Hour)**............................................................................1.7 to 5.5
Maximum Burn Time on Low Burn** ......................................................................28 to 52 Hours
Hopper Capacity (based upon hopper extension position).........................................48 to 89 Pounds
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is also
affected by the fuel size, quality, and moisture level.
** Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending
on fuel quality may occur.
Dimensions:
12"
13-1/4” (allow 14” depth in the Fireplace)
32”
Center of 4” diameter Flue is 16-7/8” above the
baseplate and 7-1/2” left of center
25-3/4” to 20”
See “Hopper Extension Set-up”
for details.
25-1/2” (allow 36” width for
control board installation)
26-1/2”
45”
28”
Door Opening
Fireplace Opening
Electrical Specifications:
Electrical Rating.........................................................................................115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence...................................................................400 (approximately)
Watts During Operation ...............................................................................180 (approximately)
Fuel:
• This heater is designed and approved for pelletized wood fuel or a mixture up to 50% corn, 50% pellets.
See page 23 for details on using a corn pellet mix.
EPA Compliance:
This heater is EPA exempt from Phase II requirements, but has been tested for emissions using EPA
test methods by OMNI Test Labs.