Filter
Top Products
20 Installation (for qualified installers only)
Travis Industries 4122104 93508117
Log Set and Coal Installation
Step 1 Before installing the log set, make sure the burner is seated correctly.
Remove the burner following the directions on page 31. Replace the
burner making sure it is seated correctly (see page 31).
Step 2
a
Place the rear log on the two
platforms at the rear of the
firebox.
These pins
insert into the
holes in the
log.
c
b
Place the left and right twig.
The pins (or bolts) on the
burner insert into the holes on
the logs.
When in place,
the logs should
look like this.
Place the embers over the front
and side edges of the burner
(do not place them over the
burner holes). Placed them in
a random pattern.
d
On newer untis, an ember chunk is
included with the heater (instead
of cast into the burner). Place it in
the location shown (it should not
cover any burner holes).