Filter
Top Products
Rev. A.5, 8/03 Page- 4
FIG. 3: STRIKE DIMENSIONS AND ASSEMBLY
Once a solid flat surface has been prepared for the magnet, it must be positioned so that its face
is parallel and centered to the strike plate. When the magnet has been experimentally
positioned this way, it's ready for mounting.
In step two, holes must be drilled for the mounting screws, and a 1/2" (12.7mm) diameter wire-
way hole should be drilled. Step three is to install the blind finishing nuts. For proper strength,
the 1/4-20 (or 6mm) mounting machine screws must be secured by these nuts. They will work
on any thickness metal header and are used as follows: A 3/8" (9.5 mm) hole is drilled following
the template for each nut. The nut is then pressed up into the hole and lightly seated with a
hammer tap. The nut is then collapsed inside the header. If you have Securitron's IK
installation kit, the nuts may be collapsed by the use of the blind nut placement tool. A special
collapsing tool is also included with each Magnalock. It is somewhat slower to use than the
more elaborate tool found in the installation kit. For its use, see Figure 4.
Step four is to make the necessary wire connections. Step five is to mount the magnet via the
supplied machine screws (see Figure 2). Don't forget to use the gold flat washers. They
prevent the narrow screw heads from digging into the resin which could cause damage. Tighten
the screws to a snug fit only. Use the supplied thread-lock on the screw threads to avoid the
possibility of the screws loosening over time. Do not drill out the mounting holes to make for
an easier fit. You may cut an internal wire and void the warranty.
Sex Bolt, Models 32, 62, 82, PN# SB-1, SB-1M (Metric)
Model 34, PN# 330-12650, 330-12750 (Metric)
Bushing (2), PN# 560-12050
Roll Pin (2), PN# 330-10800
1/4" x 1 1/4"
R
u
b
b
e
r
W
a
s
h
e
r
(
2
)
P
N
#
RW
-
1
(
P
a
c
k
o
f
2
4
)
Bushing,
Model 32,62,82
PN# 330-12000
M34, PN# 330-11900
Flathead Screw Models 32, 62, 82
5/16-18 x 1 3/4" P/N# 300-13600,
8mm-1.25mm x 40mm PN# 300-13750 (Metric)
Model 34: 1/4-20 x 2" PN# 300-12470,
6mm x 1.0mm x 50mm P/N# 300-12480 (Metric)
Length Width Depth
32 6.25" 1.62 .55
(mm) 158.8 41.1 14.0
34 6.4" 1.44 .44
(mm) 162.6 36.6 11.2
62 6" 2.75 .52
(mm) 152.4 69.9 13.2
82 9.5" 2.75 .52
(mm) 241.3 69.9 13.2