Filter
Top Products
Miscellaneous Problems
Display reads .P.P.P when
regeneration is attempted.
Power cord not attached.
Blown fuse.
Line voltage less than 100
VAC (or less than 200 VAC
for 220 unit).
Cycles dipswitch set
incorrectly.
Check power cord for connection
Replace fuse. Refer to page 22.
Check line voltage settings. Refer
to page 21.
Check input cycle settings. Refer to
page 39.
If fuse and line voltage are OK, it
may be circuit board adjustment or
component failure. Call AZI
Customer Service at 800-528-7411
or 602 470-1414.
Display reads .E.E.E Very low battery.
Recharge battery. Refer to page 17.
Replace battery. Refer to page 21.
Page 26 of 50 AZI Customer Service 800-528-7411 or 602-470-1414