Filter
Top Products
13InRow RD 10 kW Air Cooled Operation and Maintenance
Using the Display Interface
Every time power is applied to the cooling unit, the display interface initializes, causing the LEDs to
cycle and the alarm-tone to activate.
Scrolling status screens
After start-up, the interface displays the firmware revision number on the display interface. The display
interface then scrolls automatically and continuously through screens of status information.
Press the up or down arrow key to interrupt the automatic scrolling and view a specific status screen.
From a main menu screen, press
ESC to return to the scrolling status screens.
Main menu screens
On any top-level status screen, press the ENTER or ESC key to open the first
main menu screen.
All main menu choices are displayed on a series of six main menu
screens.
Status Screen Name Status Information Displayed
InRow RD • On/Standby/Idle/Service
• User Defined Name
• User Defined Location
Group • Alarms/No Alarms
• Cool Output kW
• Cool Setpoint °C (or °F)
• Maximum Rack Temperature °C (or °F )
Unit • Alarms/No Alarms
• Cool Output kW
• Air Flow l/s (liters per second) or CFM (cubic feet per minute)
• Rack Inlet °C (or °F)
On/Standby
View Alarms
Clear Alarms
View Event Log
na1636d
Clear Event Log
Configure Modbus
Set Date & Time
Set Password
Set Display Units
Configure Display
Configure Network
About InRow RD
Set Identification
Service Intervals
Configure Unit
Configure Group
View Run Hours
Set Group Setpoint
Set Group PID
Set Unit Threshlds
View Unit Status
View Group Status
Note: Once a period of inactivity - at the display interface -
exceeds the Password Timeout setting, the display interface
returns to the scrolling status screens.
For information on setting the time-out duration, see
“Timeout” on page 23.