Filter
Top Products
USER MANUAL
ENGLISH
146 2598 000(1)2005-03 A FLOORTEC R 360 P 15
SAFETY FUNCTIONS
The machine is equipped with the following safety
functions.
EMERGENCY SWITCH
It is located in an easily accessible position (see 8, Fig. B);
it has to be pressed in case of emergency, to stop all the
machine functions.
HOOD SAFETY SWITCH
It is activated when the machine hood is raised. It stops all
functions.
If the machine keeps operating when the hood is open,
contact an authorised Service Center or Retailer.
DRIVER'S SEAT MICROSWITCH
It is located inside the driver's seat and it does not allow
the machine drive system to operate if the operator is not
seated in the driver's seat.
TROUBLESHOOTING
(1): For the related procedure, see the Petrol Engine User
Manual
For further information, refer to the Service Manual,
available at any Nilfisk-Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, always remove the
following materials:
– Polyester dust filter
– Main and side brooms
– Engine oil
– Plastic components and hoses
WARNING!
When it is necessary to open the hood for
service operations, be sure to remove the
key from the ignition switch.
TROUBLE REMEDY
The engine does not start by
turning on the ignition switch
Check the engine oil level (1)
Check the petrol tap for opening
Verify if there is petrol in the tank
Check if the hood is closed
Verify if the petrol reaches the
carburettor (1)
Verify if the spark plug produces a
spark (1).
The petrol engine stops during
operation
Check the engine oil level (1)
Verify if there is petrol in the tank
The side brooms do not rotate
Lower the side brooms
Check the fuse F5 in the box (23,
Fig. U) for integrity.
The machine does not move
by pressing the pedal (5, Fig.
C).
Check if the parking brake is
disengaged
Verify if the switch (27, Fig. U) is in
the “I” position
Check that the forward/reverse
gear pedal (5, Fig. C) is not
pressed while starting the machine
through the ignition switch (2, Fig.
B), or while the operator is sitting in
the driver's seat; the
forward/reverse gear pedal (5, Fig.
C) has to be pressed only after the
operator has sit in the driver's seat
and the machine has been started.
CAUTION!
The removed components must be
disposed according to the law in force.