Filter
Top Products
ENGLISH
USER MANUAL
14 FLOORTEC R 360 P 146 2598 000(1)2005-03 A
SKIRT HEIGHT AND OPERATION CHECK
1. Drive the machine on a level ground that is suitable
for checking the skirt height.
Engage the parking brake (7, Fig. C).
2. Turn the ignition switch (2, Fig. B) to “0” position.
Side skirt check
3. Check the side skirts (16 and 17, Fig. C) for integrity.
Replace the skirts when they have cuts (1, Fig. N)
larger than 20 mm or cracks (2) larger than 10 mm
(for skirt replacement, refer to the Service Manual).
4. Check that the side skirt (16 and 17, Fig. C) height
from the ground is within 0 – 3 mm (Fig. O). If
necessary, adjust the skirt height, proceeding as
follows:
Left skirt:
– Raise the machine hood (10, Fig. C) and engage
the hood support rod (5, Fig. U).
– Loosen the knob (3, Fig. E) and remove the broom
left door (1, Fig. F), pulling it upwards to
disengage the retainers (2).
– Adjust the skirt (3, Fig. F) height by using its slots
(4).
– Reassemble in the reverse order of disassembly.
Right skirt:
– Remove the main broom, as described in the
related paragraph.
– Remove the belt (17, Fig. U) from the pulley (18);
to facilitate the operation, make the pulley (18)
rotate operating on the fan (19).
– Remove the screws (27, Fig. C) and the right door
(26) together with the belt (17, Fig. U).
On the machine, adjust the skirt (1, Fig. S) height
by using its slots (2).
– Reassemble in the reverse order of disassembly.
Front and rear skirt check
5. Remove the main broom, as described in the related
paragraph.
6. Check the front (1, Fig. R) and rear (2) skirts for
integrity.
7. Replace the skirts when they have cuts (1, Fig. N)
larger than 20 mm or cracks (2) larger than 10 mm
(for skirt replacement, refer to the Service Manual).
8. Check that:
– The front skirt (1, Fig. R) lightly touches the
ground or that it is not detached from ground (1,
Fig. P).
– The rear skirt (2, Fig. R) height from ground is
within 0 - 3 mm (1, Fig. O).
9. If necessary, adjust the skirt height by using the slots
(3, Fig. R).
10. Press the front skirt lifting pedal (8, Fig. C) and check
that the front skirt (1, Fig. Q) rotates upward of about
90° (as shown in figure); release the pedal and check
that the skirt does not remain in an intermediate
position but returns to its initial position. If necessary,
for the front skirt control cable adjustment or
replacement, refer to the Service Manual.
11. Reassemble in the reverse order of disassembly.
HOOD SAFETY SWITCH OPERATION
CHECK
While the engine is running, slightly raise the hood (10,
Fig. C) and check that the petrol engine stops
immediately.
If raising the hood (10) does not cause the engine to stop,
contact an authorised Service Center or Retailer.