Filter
Top Products
USER MANUAL
ENGLISH
146 2590 000(1)2005-03 A FLOORTEC 560 B 13
SAFETY FUNCTIONS
HOOD SAFETY SWITCH
It is activated when the machine hood is raised. It stops all
functions.
In case of machine start even when the hood is open,
contact an authorized Service Center or Retailer.
TROUBLESHOOTING
For further information, refer to the Service Manual,
available at any Nilfisk-Alto Service Center.
SCRAPPING
Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following
components:
–Battery
– Polyester dust filter
– Main and side brooms
– Electronic board
TROUBLE REMEDY
When the key is to “I” position
the machine does not start.
Check the battery connector (3,
Fig. U) for proper connection.
Check that the hood is correctly
closed.
Check the fuse (6, Fig. U) integrity.
Check that the optional battery
charger is not connected.
The side broom does not
operate.
Check the fuse (7, Fig. U) integrity.
The machine operates only
when stationary, otherwise the
red warning light turns on.
Re-charge the battery.
If the problem persists, replace the
battery.
The battery autonomy is low.
Install a battery with greater
capacity. (min. 140 Ah)
NOTE
If the machine has an optional battery charger
installed, the machine cannot operate if the
charger is not on board. In case of battery
charger malfunction, contact an authorised
Service Center.
CAUTION!
The removed components must be
disposed of properly according to the Law
in force.