Filter
Top Products
1-34 American-Lincoln
ATS 46-53 Battery
SERVICE CHART
SERVICE CHART
Check items for proper operation. If service is required, please contact an authorized American-Lincoln dealer.
For best performance, replace worn parts with genuine American-Lincoln parts.
EVERY 8 HOURS or DAILY operation check and clean/adjust if necessary:
1. Inspect panel filters for damage and clean them.
2. Check hydraulic fluid level.
3. Check all flaps for wear or damage.
4. Check brooms for wear or damage, adjust as required.
5. Check panel filters (clean side) for leakage.
6. Check brake pedal and parking brake.
7. Check hydraulic oil filter.
8. Check battery electrolyte level (unless maintenance-free battery).
9. Check all fluid system components for leaks.
50 HOUR (WEEKLY) MAINTENANCE CHECKLIST
10. Check solution tank (recycling or ESP system).
11. Check solution filter screen (recycling or ESP system).
12. Check recovery tank.
13. Check recovery tank screens and filters.
14. Inspect scrub brushes for wear or damage.
15. Inspect rear and side squeegees for wear or damage.
16. Check battery electrolyte level (unless maintenance-free battery).
17. Check all hydraulic hoses for wear or cuts.
18. Rotate main brush (end-over-end).
19. Clean or replace panel filters.
20. Lubricate dump system and drive wheel pivot points.
100 HOUR MAINTENANCE CHECKLIST
21. Lubricate drive wheel, swivel wheel bearings, and steering rack guide.
22. Lubricate front wheel bearings.
23. Lubricate all moving joints.
24. Check brake shoes for wear and adjust accordingly.
25. Lubricate all 3 DANHOUSER bushings with NAPA #765-1363 or equivalent anti-seize lubricant. The
bushings are located on the steering, scrub deck lift, squeegee lift, variable dump hopper door.
250 HOUR MAINTENANCE CHECKLIST
26. Lubricate squeegee casters.
27. Clean solution tank and filter screen.
28. Replace hydraulic filter element.
400 HOUR MAINTENANCE CHECKLIST
29. Clean hydraulic reservoir.
30. Clean hydraulic intake strainer.
31. Change hydraulic fluid.
500 HOUR MAINTENANCE CHECKLIST
32. Inspect brushes on pump and drive motors for wear. Replace as needed.
33. Inspect drive system cables for wear.