Nilfisk-ALTO 114RS SWEEPER Vacuum Cleaner User Manual


 
1-10 American-Lincoln Technology
114 RS Operator’s Manual
YOUR 114 RS BATTERY MACHINE HAS BEEN SHIPPED COMPLETE, BUT DO NOT ATTEMPT TO OPERATE
WITHOUT READING THE FOLLOWING INSTRUCTIONS.
Uncrate the machine and remove all packing material. Inspect the machine for possible shipping damage.
Install brooms, as outlined in the Service Instructions Section of this manual. Install batteries as follows (if not
included):
1. Turn the key to the “OFF” position.
2. Unplug the polarized connector located next to the operator’s seat.
3. Lift the battery compartment cover and engage the safety latch.
4. Use a battery-lifting device with a 150 lb. (68 KG) capacity to place the batteries in the battery
compartment.
5. Install Battery Cables. (See Page 45 for detailed connection information)
6. Charge batteries (See battery charging procedure in the Service Instructions Section of this Manual)
7. Disengage battery cover safety latch and carefully lower cover.
8. Plug the polarized connector into the receptacle located next to the operator’s seat.
9. READ THIS MANUAL before Attempting to Operate the Sweeper.
WARNING
Hydrogen gas is formed during the charging operation and is explosive! Only charge batteries in a well-venti-
lated area with the lid open. Avoid any open flame or electrical sparks. Pulling out the charger plug with the
timer on will cause an arc and must be avoided.
MACHINE PREPARATION
C0458 FIGURE 1