Filter
Top Products
;I
Turning Off the
lnterlor
Zones and Entrance Delay
Control station key 4 may be used to turn the interior zones off prior to arming. This
will allow the system to alarm instantly if the entrance door is opened, while armed.
1.
Press the 4 key and hold for three seconds.
2.
When interior defined zones are turned off, the corresponding Zone indicators
will flash. The flashing will stop 30 seconds after the system is armed.
3.
Arm the system by entering your User Code.
Note: Upon disarming, the interior zones automatlcally w-enable
unless
your Installer has altered
this
feature through programming.
Q
Automatic Interior Off/Delay Off
Your
system may have been programmed to automatically turn the interior zones
off if you arm and do not leave the premises before the exit delay time expires.
The
entrance delay may also
be
programmed to automatically turn off at this time. When
the system is disarmed, the interior and delay
wilI
return to their normal on or off
state. See your security representative for details.
Q
Two
Digit
Arming
Your system may have been programmed with an abbreviated arming feature.
When this feature is enabled, only the first two digits of your User Code will be
required to arm the system
and
perform other features. Disarming however, will still
require the entire code sequence.
If the READY indicator is off, one or more detection devices such as a door or
window has been left open. The system cannot be armed. One or more of the six
ZONE indicators will also be lighted indicating the area of protection that is at fault.
Use the pull out zone I.D. card on
the
control station to define the area of protection
assigned to each zone.
NOTE:
If
an attempt Is made to arm the system
with
the READY light off,
a three second error tone wilt be
emltted
to alert you that the system did
not arm.
4