Filter
Top Products
Your system may utilize a conventional key switch for arming and disarming the
system. Arming and disarming with a key switch is performed as follows:
cl
1.
2.
3.
0
1.
2.
Arming
Verify that the BEADY light is on.
Insert your key into the key switch and turn. Hold for one second and release.
The
red ARMED light will blink during the exit delay cycle and then light steady
when the system arms.
Disarming
Insert your key into the key switch and turn. Hold for one second and release.
The red
ARMED
light will go out indicating that the system is disarmed.
m
U.L. Note: The control is not listed to Standard U.L.294 Access Control Units
If your system was purchased with the ACCESS feature, the control station can be
used to switch other devices on and off or as a timed switch. This feature is most
commonly used to activate an electric door release or switch lights on and off.
Consult your security representative for more information.
The
“
*
”
key may be used to:
D Silence the control station sounder and the audible output during Auxiliary “A”
(Fire) and Auxiliary “C” (Emergency) alarms.
Cl
Silence the control station sounder during Burglar alarms.
Ct
Exit the audible test mode.
NOTE:
Pressing
the
*
*
*’
key does not
resef
alarms or cancel reporting
to the central statlon.
Your system is capable of being serviced remotely from the alarm company’s
service office providing that the system is set up for
Remote Programming. The
system provides a means of verifying that this feature is enabled. See your security
representative for more information.
10