B-12
1600XP Series Installation and Operation Manual
1600XP Command Parameters Table
Cmd
ID
Description
on LCD
Brief Description Location Map Example
Rqd Security
Level to change
By
Tab Block
655 Batt Test Freq* Max Battery Test Frequency
- Non-volatile conguration. Default from fac-
tory is Monthly.
Settings C&C Monthly Nonchangeable
Changeable
Changeable
User
Administrator
Service
656 Sys. Temp.
Comp.
System Temperature Compensation Settings C&C -5 Changeable Service
657 Service Port
Mode
Service Port Mode - Terminal or TUPS 2.0 Settings C&C 1 Changeable Service
658 En Restart Enable Restart
- Non-volatile conguration. After shutdown by
battery, UPS will restart if input power recover.
Default from factory is Enable.
Settings C&C Enable Nonchangeable
Changeable
Changeable
User
Administrator
Service
659 Restart Delay Restart Delay Settings C&C 10 Sec Nonchangeable
Changeable
Changeable
User
Administrator
Service
660 En AutoXfer Enable Auto Transfer
- Non-volatile conguration. Enable auto
transfer when current limit occurs. It will switch
bypass and On-Line mode.
Settings C&C Enable Nonchangeable
Changeable
Changeable
User
Administrator
Service
662 AutoXfer Win-
dow
Auto Transfer Time Window
- Non-volatile conguration. Default from fac-
tory is 3 Seconds.
Settings C&C 3 Sec Nonchangeable
Changeable
Changeable
User
Administrator
Service
663 Srv Port Baud* Service Port Baud Rate
- Non-volatile conguration. Default from fac-
tory is 57600.
Settings C&C 57600 Nonchangeable
Changeable
Changeable
User
Administrator
Service
680 Reload All EE* Reload all EEPROM Settings C&C 0 Changeable Service
681 SNMP Port
Mode
SNMP Port Mode: Terminal or Toshiba 2.0 Settings C&C 1 Changeable Service
682 Special
Purpose
(Call Factory for Further Information) Settings C&C Nonchangeable
Nonchangeable
Changeable
User
Administrator
Service
683 Flt Clear Mask
Lo
Fault Clear Mask Low Settings C&C 0x0000 Changeable Service
684 Flt Clear Mask
Hi
Fault Clear Mask High Settings C&C 0x0000 Changeable Service
