Maintenance Section 5 Page 47
MSD SABER SERIES SHEARS
FIGURE 5-47
NOTICE
SPEED VALVE ADJUSTMENT continued
SPEED VALVE ASSEMBLY TORQUE VALUES: MSD 1500 - 4500 SHEARS
Proper bolt installation is critical to ensure the safe and effi cient operation of the speed valve.
Carefully follow the steps below to properly install bolts.
Please note that the parts illustrated below (Figure 5-47) and on pages 5-50 through 5-51 are for
#513029, which is used in MSD 1500, 2000, 2500, 3000, 4000 and 4500 shears. For MSD 7500
and above, refer to your parts catalog for the speed valve part number and call Stanley LaBounty for
torque values. MSD 1000 models do not have speed valves.
1. Always replace bolts and nuts with the same size and class of fastener. Replacement fasteners
can be ordered from the Stanley LaBounty Parts Department to ensure the correct part is used.
Unless otherwise specifi ed, use class 10.9 metric hex head capscrews, class 10.9 metric fl at head
capscrews, and class 12.9 metric socket head capscrews.
2. Make sure bolts, nuts and bolt holes are free of dirt, oil, grease and other contaminants. .
3. The torque values in this manual are for use with non-plated fasteners with clean, dry threads.
These values are suitable for use with or without thread adhesives, such as Loctite™ products.
ITEM PART NUMBER DESCRIPTION QTY TORQUE
5 512210 Socket Head Screw M8X35 4 32 ft lb/43 Nm
6 513133 Socket Head Screw M10X45 6 62 ft lb/84 Nm
5
6
SPEED VALVE ASSEMBLY
P/N 513029 USED IN
MSD 1500,2000, 2500,
3000,4000 AND 4500
SHEARS
CHECK VALVE
ASSEMBLY
SEE PAGE 5-52
PILOT VALVE ASSEM-
BLY
SEE PAGE 5-51
MAIN VALVE
ASSEMBLY
SEE PAGE 5-50
