Connections & Setup
Chapter 1 17
Step 3: Configuring for a VCR
1. If your TV is connected to a VCR, press OK.
If it is not, highlight No and press OK (a screen will
appear reminding you to connect your G-LINK cable
to your TV and VCR.).
2. Use the up and down arrow buttons to highlight the
brand of your VCR that is connected to the TV and
press OK.
If your brand isn’t listed, highlight Not Listed and
press OK.
3. Tune your VCR to channel 02. Next, turn OFF your
VCR. When you complete these steps, press OK to
begin testing.
Important Note: When code testing is in
progress, don’t touch your TV, VCR, or any of
the remote controls for these products.
1571963A.01 Setup 4/9/02, 12:58 PM17
