3.5.2.5 Set command
Set command is to change the parameter of the switch functions. The follow table lists the set commands
and the equivalent usages.
Command Description
set channel Set ports to be channel
set default Set system load default parameters
set enable password Set the password for the privileged level of the CLI
set igmp-snooping disable Disable igmp snooping
set igmp-snooping enable Enable igmp snooping
set ip http server disable Disable http server
set ip http server enable Enable http server
set ip telnet server disable Disable telnet server
set ip telnet server enable Enable telnet server
set mirror Enable/Disable mirror function
set mirror capture-port Set a port to capture traffic
set mirror monitored-port egress Capture egress traffic
set mirror monitored-port ingress Capture ingress traffic
set multicast router Set multicst router port
set password Set the password for telnet
set port disable Disable a port
set port duplex Set port transmission type
set port enable Enable a port
set port flow-control Set port traffic flowcontrol
set port rate-shaping egress Set port egress rate-shaping rate
set port rate-shaping ingress Set port ingress rate-shaping rate
set port rate-shaping egress Set port egress rate-shaping rate
set port rate-shaping ingress Set port ingress rate-shaping rate
set port spantree <port_num> portco Set spanning tree port cost
set port spantree <port_num> portfa Set spanning tree PortFast feature
set port spantree <port_num> portpr Set spanning tree port priority
set port speed Set port transmission speed
set port storm-limit mode Set port storm limit mode
set port storm-limit rate Set port storm limit rate
set qos map cos-queue-map Set the queue number of each cos
set qos map dot1p-cos-map Set the cos value of each dot1p priority
set qos map mac-cos-map Set MAC based qos
set qos map port-cos-map Set port's cos
