WR3000 4-Port Wireless DSL/Cable Router
®
51
7.3 Confi guring WEP Encryption - Continued
Table continued from preceding page.
Intra-BSS traffi c is traffi c between wireless stations in the BSS. Select this check box to
Intra-BSS traffi c is traffi c between wireless stations in the BSS. Select this check box to
enable Intra-BSS Traffi c.
Select this check box to enable the Breathing LED, also known as the WR3000 Wireless
Select this check box to enable the Breathing LED, also known as the WR3000 Wireless
The blue WR3000 Wireless Router LED is on when the WR3000 Wireless Router is on
and blinks (or breaths) when data is being transmitted to/from its wireless stations. Clear
the check box to turn this LED off even when the WR3000 Wireless Router is on and
data is being transmitted/received.
Use this fi eld to set a maximum number of wireless stations that may connect to the
Use this fi eld to set a maximum number of wireless stations that may connect to the
Enter the number (from 1 to 32) of wireless stations allowed.
Set the output power of the WR3000 Wireless Router in this fi eld. If there is a high density
Set the output power of the WR3000 Wireless Router in this fi eld. If there is a high density
of APs within an area, decrease the output power of the WR3000 Wireless Router to
reduce interference with other APs.
11dBm (50mW), 13dBm (32mW), 15dBm (20mW)
to save your changes back to the WR3000 Wireless Router.
reload the previous confi guration for this screen.
The MAC fi lter screen allows you to confi gure the WR3000 Wireless Router to give exclusive
access to up to 32 devices (Allow Association) or exclude up to 32 devices from accessing the
WR3000 Wireless Router (Deny Association). Every Ethernet device has a unique MAC
WR3000 Wireless Router (Deny Association). Every Ethernet device has a unique MAC
(Media Access Control) address. The MAC address is assigned at the factory and consists of
six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the
MAC address of the devices to confi gure this screen.
To change your WR3000 Wireless Router’s MAC fi lter settings, click
MAC Filter tab. MAC Filter
The screen appears as shown on the next page.
