WR3000 4-Port Wireless DSL/Cable Router
®
152
19.2 TCP/IP Ethernet and DHCP Setup - Continued
Follow the instructions in the table below to confi gure the DHCP fi elds.
your WR3000 Wireless Router can assign IP
addresses, an IP default gateway and DNS servers to Windows 95,
Windows NT and other systems that support the DHCP client.
the DHCP server will be disabled. If set to
WR3000 Wireless Router acts as a surrogate DHCP server and relays
DHCP requests and responses between the remote server and the
clients. Enter the IP address of the actual, remote DHCP server in the
Remote DHCP Server in this case.
When DHCP is used, the following items need to be set:
When DHCP is used, the following items need to be set:
This fi eld specifi es the fi rst of the contiguous addresses in the IP
This fi eld specifi es the fi rst of the contiguous addresses in the IP
This fi eld specifi es the size or count of the IP address pool.
This fi eld specifi es the size or count of the IP address pool.
Press [SPACE BAR] to select
From ISP, User Defi ned, DNS Relay
From ISP, User Defi ned, DNS Relay
The DNS servers are passed to the DHCP clients along with the IP
address and the subnet mask.
Enter the IP addresses of the DNS servers. This fi eld is available
when you select User-Defi ned in the fi eld above.
fi eld above then enter the IP address
fi eld above then enter the IP address
of the actual remote DHCP server here.
Follow the instructions in the following table to confi gure TCP/IP parameters for the Ethernet port.
Enter the (LAN) IP address of your WR3000 Wireless Router in dotted
Enter the (LAN) IP address of your WR3000 Wireless Router in dotted
Your WR3000 Wireless Router will automatically calculate the subnet
mask based on the IP address that you assign. Unless you are
implementing subnetting, use the subnet mask computed by the
Press [SPACE BAR] to select the RIP direction. Choices are
Press [SPACE BAR] to select the RIP direction. Choices are
Continued on the next page.
